7.3.10

Q1.                    The length of a file is the distance from.

a)  the face to the tang and does not include the tang

b)  the point or tip to the heel and does not include the tang

c)  the point or tip to the tang and does not include the heel

Q2.                    The portion of the file on which the teeth are cut is called the

a)  point

b)  heel

c)  face

Q3.                    The tapered end that fits into the handle is called the

a)    heel

b)    tang

c)    point

Q4.                    In aircraft work  the unit of measure most commonly used is the

a)    Centimeter

b)    Inch

c)    feet

Q5.                    The ……….. can be used to check angles and also may be set at any desired angle to draw lines

a)    centre head

b)    the square or stock head

c)    protactor head

Q6.        The ……….. is designed to serve the aviation mechanic in the same way a pencil or pen serves a writer

a)    caliper

b)    scriber

c)    divider

Q7.      In general  it is used to scribe or mark lines on metal surfaces.

a)    caliper

b)    divider

c)    scriber

Q8.        The scriber is made of tool steel  4 to 12 inches long  and has two needle pointed ends

a)    scriber

b)    caliper

c)    divider

Q9.      Which tools has two legs joined at the top by a pivot

a)    Dividers and pencil compasses

b)    Scriber

c)    Straightedge

Q10.     They are used to scribe circles and arcs and for transferring measurements from the rule to the work.

a)                    Scriber

b)                    Straightedge

c)                    Dividers and pencil compasses